Hello. Thank you so much for your support and engagement with our teams. Your feedback helps drive our development process and makes our products better.

In this release, we’ve included the following improvements to your print process:

We can’t wait to hear from you about this release. Keep printing great parts and sharing your feedback. We appreciate it, and it makes our products better.

If you have any questions, please contact the Carbon Service Team at [email protected]

Update 4/28: This feature is currently turned off for everyone. If you would like to use this feature. It will require an additional update to your software.

After you analyze your project, we will inform you of islands we have found on your part(s). You can click through to each slice to view where the islands are.

Note: Small islands that might not need additional support may be flagged by the island detector. Dental models will often have small islands on the undersides. These islands do not require supports and will not cause defects or print failures due to their small size





For those with washers, we will show you estimated increase of soil load to your washer based on the solvent in the washer.



We love hearing from you about your workflow, your parts, and how to improve. Keep your insightful feedback and ratings coming. We read them carefully and follow up when you request that we contact you. If you prefer real-time feedback, you can always contact the Carbon Service Team, [email protected].