Disclaimers
Pac-Dent Rodin Sculpture is a product of Pac-Dent™.
Because this resin is not manufactured by Carbon, the following disclaimer applies to Rodin’s resin including mechanical properties, handling, printing, washing, and curing. It does not apply to Carbon’s hardware, software, or accessories.
The training contained herein includes the resin manufacturer’s information available as of the release date of this course. This information is subject to change from time to time without notice. You are responsible for determining that such information is correct and current as of the date of use and sufficient for your intended purpose.
Training source: RODIN Sculpture Resin Instructions for Use
There you will find:
- Instructions for use (including orientation & supporting, mixing, design recommendations, and post processing instructions)
Pac-Dent Rodin Sculpture has been developed specifically for use as a dental device. All of the content herein is written to produce dental devices.
All validation of material properties, orientation & support strategy, print settings, washing and curing procedures was performed using teeth geometries on a standard cassette using manual (non-Smart Part Washer) washing and a Pac-Dent approved UV curing device.
Usage of this material outside of these conditions will result in limited Carbon support.
Contact Carbon for more information.
Pac-Dent Rodin Sculpture requires software version 1.41 or later.
Contact Carbon for more information.