Disclaimers

legal disclaimer keystone industries® keyprint® keydenture try in™ is a product of keystone industries because this resin is not manufactured by carbon, the following disclaimer applies to keystone’s resin including mechanical properties, handling, printing, washing and curing it does not apply to carbon’s hardware, software or accessories the training contained herein includes the resin manufacturer’s information available as of the release date of this course this information is subject to change from time to time without notice you are responsible for determining that such information is correct and current as of the date of use and sufficient for your intended purpose training source https //docs carbon3d com/files/technical data sheets/pq certificate carbon m2 m3 keydenture tryin pdf https //keyprint keystoneindustries com/keydenture try in/ there you will find instructions for use (including required accessories, dispensing, and post processing instructions) purchasing information technical data sheet (tds) material safety data sheet (sds) non dental usage disclaimer keystone industries® keyprint® keydenture try in™ has been developed specifically for use as a dental device all of the content herein is written to produce dental devices all validation of material properties, orientation & support strategy, print settings, washing, and curing procedures was performed using denture try in geometries on a standard cassette using manual (non smart part washer) washing and keystone® approved curing devices usage of this material outside of these conditions will result in limited carbon support contact carbon for more information