FP3D is manufactured by Keystone Industries.

Because this resin is not manufactured by Carbon, the following disclaimer applies to the mechanical properties FP3D. It does not apply to Carbon’s hardware, software or accessories.

The training contained herein includes the resin manufacturer’s information available as of the release date of this course. This information is subject to change from time to time without notice. You are responsible for determining that such information is correct and current as of the date of use and sufficient for your intended purpose.

The Material Safety Data Sheet (SDS) is available at https://keyprint.keystoneindustries.com



FP3D has been developed specifically for use as dental devices. All of the content herein is written to produce dental devices.

All validation of material properties, orientation & support strategy, print settings, washing and curing procedures was performed using partial denture geometries on a standard cassette using manual (non-Smart Part Washer) washing and validated thermal and UV curing devices.

Usage of this material outside of these conditions will result in limited Carbon support.

Contact Carbon Support for more information.