Disclaimers

legal disclaimer sprintray onx tough 2 is a product of sprintray™ because this resin is not manufactured by carbon, the following disclaimer applies to sprintray’s resin including mechanical properties, handling, printing, washing, and curing it does not apply to carbon’s hardware, software, or accessories the training contained herein includes the resin manufacturer’s information available as of the release date of this course this information is subject to change from time to time without notice you are responsible for determining that such information is correct and current as of the date of use and sufficient for your intended purpose training source sprintray onx tough 2 instructions for use there you will find instructions for use (including orientation & supporting, mixing, design recommendations, and post processing instructions) non dental usage disclaimer sprintray has been developed specifically for use as a dental device all of the content herein is written to produce dental devices all validation of material properties, orientation & support strategy, print settings, washing and curing procedures was performed using teeth geometries on a standard cassette using manual (non smart part washer) washing and a sprintray approved uv curing device usage of this material outside of these conditions will result in limited carbon support contact carbon for more information