Disclaimers

legal disclaimer flexcera smile and flexcera smile ultra+ are products of desktop health™ because these resins are not manufactured by carbon, the following disclaimer applies to desktop health’s resins including mechanical properties, handling, printing, washing, and curing it does not apply to carbon’s hardware, software, or accessories the training contained herein includes the resin manufacturer’s information available as of the release date of this course this information is subject to change from time to time without notice you are responsible for determining that such information is correct and current as of the date of use and sufficient for your intended purpose training sources flexcera smile ultra+ desktop health instructions for use flexcera smile desktop health instructions for use there you will find instructions for use (including accessories, design recommendations, and post processing instructions) non dental usage disclaimer flexcera smile and flexcera smile ultra+ have been developed specifically for use as dental devices all of the content herein is written to produce dental devices all validation of material properties, orientation & support strategy, print settings, washing and curing procedures was performed using teeth geometries on a standard cassette using manual (non smart part washer) washing and a desktop health approved uv curing device usage of these materials outside of these conditions will result in limited carbon support contact carbon for more information required software disclaimer flexcera smile and flexcera smile ultra+ require software version 1 40 or later contact carbon for more information