Disclaimers

legal disclaimer dentca® denture teeth for carbon printers is a product of dentca® because this resin is not manufactured by carbon, the following disclaimer applies to dentca’s resin including mechanical properties, handling, printing, washing and curing it does not apply to carbon’s hardware, software or accessories the training contained herein includes the resin manufacturer’s information available as of the release date of this course this information is subject to change from time to time without notice you are responsible for determining that such information is correct and current as of the date of use and sufficient for your intended purpose training source https //www dentca com/blog/home/products/materials for carbon printers there you will find directions for use (including required accessories, dispensing and post processing instructions) purchasing information technical data sheet (tds) material safety data sheet (sds) non dental usage disclaimer dentca® denture teeth for carbon printers has been developed specifically for use as a dental device all of the content herein is written to produce dental devices all validation of material properties, orientation & support strategy, print settings, washing and curing procedures was performed using teeth geometries on a standard cassette using manual (non smart part washer) washing and a dreve pcu led uv curing device usage of this material outside of these conditions will result in limited carbon support contact carbon for more information