Disclaimers

legal disclaimer flexcera base and flexcera base ultra+ are products of desktop health™ because this resin is not manufactured by carbon, the following disclaimer applies to desktop health’s resin including mechanical properties, handling, printing, washing, and curing it does not apply to carbon’s hardware, software, or accessories the training contained herein includes the resin manufacturer’s information available as of the release date of this course this information is subject to change from time to time without notice you are responsible for determining that such information is correct and current as of the date of use and sufficient for your intended purpose flexcera base manufacturer training https //knowledge desktophealth com/hc/en us/articles/4420538637079 flexcera base instructions for use https //knowledge desktophealth com/hc/en us/articles/4420538637079 flexcera base instructions for use flexcera base ultra+ manufacturer training https //knowledge desktophealth com/hc/en us/articles/13003470689559 flexcera base ultra instructions for use https //knowledge desktophealth com/hc/en us/articles/13003470689559 flexcera base ultra instructions for use non dental usage disclaimer flexcera base and flexcera base ultra+ have been developed specifically for use as dental devices all of the content herein is written to produce dental devices all validation of material properties, orientation & support strategy, print settings, washing and curing procedures was performed using teeth geometries on a standard cassette using manual (non smart part washer) washing and a desktop health approved uv curing device usage of this material outside of these conditions will result in limited carbon support contact carbon for more information